Operation, Warning – Ryobi RY6200 User Manual

Page 8

Advertising
background image

Page 8

Fig. 2

WARNING:

If any parts are missing, do not operate tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.

IMPORTANT CHARGER INFORMATION

The battery pack for your Circular Saw should be charged
with charger part number 1412001. The part number will be
found on a plate located on the bottom of your charger.
Before using your charger, it is extremely important that
you familarize yourself with the LED functions of the charger.
See Figure 2 .

LED FUNCTION OF CHARGER

See Figure 2.

LED WILL BE LIGHTED TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:

Red LED lighted = Fast Charging Mode

Green LED lighted = Fully Charged Battery Pack

Yellow and Green LED Lighted = Control Charge or

Defective Battery Pack.

CHARGING BATTERY PACK

The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it prior to use.

Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (cutting followed by re-
charging) for them to fully charge.

TO CHARGE

Charge battery pack only with the charger provided.

Make sure power supply is normal house voltage,
120 volts, 60 Hz, AC only.

Connect charger to power supply.

Place battery pack in charger.

See Figure 3. Align raised

rib on battery pack with groove in charger.

Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.

Normally, the yellow and green lights on the charger will
come on. This indicates charger is in control charge
mode and should switch to fast charge mode within 5
minutes. When charger is in fast charge mode the red
light will come on. If after a period of 15 minutes the
yellow and green lights remain on, remove the battery
pack, wait 1 minute and reinsert battery pack in charger.
If the yellow and green lights continue to remain on an
additional 15 minutes, the battery pack is damaged and
will not accept charge.

When your battery pack becomes fully charged, the red
light will turn off and the green light will turn on.

BATTERY

CHARGER

GREEN LIGHT "ON"

INDICATES FULLY

CHARGED

YELLOW AND GREEN LIGHTS "ON"

INDICATES CONTROL CHARGE OR

POSSIBLE FAULTY BATTERY

RED LIGHT "ON"

INDICATES FAST

CHARGING MODE

Fig. 3

BATTERY

PACK

BATTERY

CHARGER

After normal usage, 1 hour of charge time is required to
be fully charged. A minimum charge time of 1 to 1-1/2
hours is required to recharge a completely discharged
tool.

The battery pack will become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.

DO NOT place charger in an area of extreme heat or
cold. It will work best at normal room temperature.

IMPORTANT INFORMATION FOR RECHARGING
HOT BATTERIES

When using your saw continuously, the batteries in your
battery pack become hot. You should let a hot battery pack
cool down for approximately 30 minutes before attempting to
recharge.

Note: This situation occurs when continuous use of your saw
causes the batteries to become hot. It does not occur under
normal circumstances. Refer to "Charging Your Battery
Pack"
for normal recharging of batteries. If the charger does
not charge your battery pack under normal circumstances,
return both the battery pack and charger to your nearest
Ryobi Authorized Service Center for electrical check.

OPERATION

Advertising