Radio Shack XTS 36 - Manual

© 1995 Tandy Corporation.
All Rights Reserved.
Optimus and Radio Shack are registered trademarks used by Tandy Corporation.
XTS 36 MINI SPEAKER
Cat. No . 40-1994
OPTIMUS
CONNECTING THE SPEAKER
You need speaker wire (not supplied) to con-
nect the speaker to your receiver or amplifier.
We recommend you use wire that is color-cod-
ed or marked on one side. Use 18-gauge or
larger speaker wire for distances up to 50 feet.
For greater distances, use 16-gauge wire. Your
local Radio Shack store has a wide selection of
speaker wire.
Note: For maximum bass response and the
best overall performance, be sure the polarities
match when you connect the speaker to the re-
ceiver or amplifier (positive to positive and neg-
ative to negative).
1. With the speaker in its appropriate loca-
tion, measure the distance from the
speaker to the receiver or amplifier. Then
route the proper length of speaker wire
from the speaker to the receiver or ampli-
fier.
Cautions:
• Avoid routing the speaker wire near
other electrical wires.
• Do not nail or staple the speaker wire.
2. Split apart 4 inches of speaker wire on
each end.
3. Strip 1 /
4
inch of insulation from each wire’s
end. Then twist the ends of the wire to
secure any loose strands.
4. While pressing and holding down the black
(negative) terminal tab on the back of the
speaker, insert one end of the negative
bare wire into the opening. Then release
the tab.
1/4 Inch
4 Inches
Speaker Wires
SPECIFICATIONS
Frequency Response 140 Hz— 20 kHz
Power Handling 15 watts (RMS)
Maximum Power 30 watts
Impedance 8
Speaker Complement 3” (7.62 cm) full range
Enclosure: Sealed high density plastic cabinet for
extended bass response
Dimensions: 5 5 / 8 ¥ 3 9 / 16 ¥ 3 3 / 8 Inches (HWD)
(14.2 Ч 9.0 Ч 8.5 cm )
Shipping Weight: 1.4 lbs. (0.6 kg)
Ω
40-1994.fm Page 1 Wednesday, August 11, 1999 8:11 AM