RTI U1 - Manual (Page 15)

U1 Waterproof Wireless Controller
8
PROGRAMMING
The U1 is programmed using RTI’s TheaterTouch Designer 3.0 or
higher software. RTI dealers can download the software free of
charge from:
www.rticorp.com/dealers
A PC running Windows ® 98SE or higher with a USB port is
required. The required USB cable is included with the RTI IR-PRO
dealer kit.
Note: The U1 will not operate normally while connected to a
PC’s USB port. Make sure you disconnect it from the PC to
transmit commands. In addition, the U1 will not be able to
sync with a PC’s USB port while it is transmitting a
command or running a macro.
ASSEMBLY
In order to simplify the initial programming process, the U1 is
shipped without the eight enclosure screws installed. When
installing these screws, make sure the pressure is evenly
distributed around the entire outer gasket. You should gradually
tighten each screw, rotating among them around the unit (similar
to tightening the bolts on a spare tire). Each screw should
eventually be tightened firmly, but not over-tightened.
OPERATING
The operation of the U1 is highly dependant on the specific
programming that you create for it. Although the small number of
buttons and lack of a display gives the U1 a very basic
appearance, it is actually capable of many of the same advanced
macro features found in all RTI system controllers. For instance,
you can assign multiple different functions to a button, depending
upon whether you press momentarily, press and hold, or double-
click the button.