Ryobi BS903 - Manual (Page 18)

18
OPERATION
TILTING THE TABLE
See Figure 13.

Loosen the table lock knob slightly.
 Turn the angle adjustment knob, tilting the saw table
toward the front of the saw housing until it reaches the
desired angle.
 Using the scale indicator, check angle markings.
 Retighten the table lock knob to hold saw table securely
in place.
USING THE MITER GAUGE
See Figures 13 and 14.
The miter gauge can be turned 60° to the right or left.

Loosen the lock knob on the miter gauge.
 With the miter gauge in the miter gauge slot, rotate the
gauge until the desired angle is reached on the index
scale.
 Retighten the lock knob.
NOTE: For convenience, store the miter gauge in the slot
provided on the back of the band saw.
USING THE SLIDING TABLE EXTENSION
See Figure 15.
The sliding table extension provides the operator with
additional table width for supporting wider workpieces.

Loosen the table extension knobs beneath the sliding
table extension as shown in figure 15.
 Slide the table extension to the desired width.
 Retighten the table extension knobs.
TABLE LOCK KNOB
SCALE INDICATOR
SAW
TABLE
LOCK
KNOB
Fig. 14
MITER
GAUGE
MITER
GAUGE
SLOT
SLIDING TABLE
EXTENSION
Fig. 15
Fig. 13
TABLE EXTENSION
KNOBS
ANGLE
ADJUSTMENT KNOB
TURN LEFT TO
LOOSEN