Ryobi FL96 - Manual (Page 4)

Page 4
OPERATION
Fig. 2
BATTERY
PACK
DEPRESS LATCHES TO
RELEASE BATTERY PACK
CHARGING FLASHLIGHT
If your flashlight did not come in a cordless kit with other
cordless products, a battery pack and charging assembly
were not included. If you decide to purchase a battery pack,
request recommended battery pack part number 1311146.
If you decide to purchase a charging assembly, request
recommended charging assembly part number 1411133,
1411140 or 981351-001. If your flashlight came with a kit,
use the battery pack and charging assembly included with
the kit.
TO CHARGE BATTERY PACK:
See Figure 1.
■ Charge battery pack only with the charging assembly
recommended.
■ Make sure power supply is normal household volt-
age, 120 volts, 60 Hz, AC only.
■ Connect charging assembly to power supply.
■ Place battery pack in charging assembly then press
down on battery pack to be sure contacts on battery
pack engage properly with charging assembly con-
tacts.
■ For charger part number 1411140 or 981351-001:
The red light (LED) should turn on and will remain on
even when charging is complete. Red light will not go
off until you remove the battery pack.
■ For charger part number 1411133:
If red light does not come on after 1 hour, this indicates
a problem with the battery pack.
If red light comes on after a short period to maximum of
1 hour, this indicates battery pack is deeply discharged
but is now charging normally.
If red light comes on immediately, this is normal charg-
ing.
■ After normal usage, 3 hours of charging time is re-
quired to be fully charged. A minimum charge time of 6
hours is required to recharge a completely discharged
battery pack.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2.
■ Begin with a fully charged battery pack.
■ Orient battery pack so that raised rib on battery pack
aligns with groove inside flashlight. Battery pack is
designed to fit only one way in light handle.
■ Insert battery pack, making sure latches on each side
of battery pack snap in place and battery pack is se-
cure in light before use.
Fig. 1
CHARGING ASSEMBLY
(ONLY INCLUDED WITH KITS)
BATTERY PACK
(ONLY INCLUDED
WITH KITS)
LATCHES
CHARGE
INDICATOR
LIGHT (LED)
CAUTION:
When placing battery pack in your flashlight, be sure raised
ribs on battery pack aligns with groove inside light handle
and latches snap in place properly. Improper assembly of
battery pack can cause damage to internal components.
■ To remove battery pack, locate latches on end of bat-
tery pack and depress to release battery pack from
your light.