Ricoh GX100VF - Manual (Page 188)

186
7
A
p
p
e
ndi
c
e
s
7 Appendices
If an error message is displayed on the screen, take the
corresponding action.
Troubleshooting
Error Messages
Error Message Cause and Action Refer to
INSERT CARD No card is loaded. Insert a card. P.30
USE THE SETUP MENU TO SET
THE DATE. The date is not set. Set the date. P.161
FILE NUMBER OVER LIMIT The file number limit has been exceeded. Use another card. P.159
P.160
UNMATCHED FILE The camera cannot display this file. Check the file contents
on your computer, and then delete the file. -
INSUFFICIENT MEMORY.
CONTINUE? Because there is not sufficient capacity on the card, all the
files cannot be copied. Use another card. P.27
PROTECTED You are trying to delete a protected file. P.115
CARD IS WRITE-PROTECTED. The card is “Locked (write-protected)”. Unlock the card. P.27
PRINT SETTINGS CANNOT BE
SET FOR THIS FILE. This file (movie or other file) cannot be selected for printing. -
INSUFFICIENT MEMORY Files cannot be stored. Make sure there is enough free
space or delete unwanted files. P.56
P.137
P.138
The image print number limit has been exceeded. Select an
image and set the number to 0. -
FORMAT INTERNAL MEMORY You must format the internal memory. P.138
INITIALIZE THE CARD. The card is not formatted. Format the card with this camera. P.137
CARD ERROR Reformat the card. If, after doing so, the error message still
appears, the card may be faulty. Do not use the card. P.137
WRITING TO DATA Writing file to memory. Wait until writing finishes. -
NO FILE There are no files that can be played back. -
CANNOT RECORD The number of remaining shots is 0. Switch to another card
or the internal memory. P.27
REMOVE LENS CAP. The camera does not start because the lens cap is still on
the camera. Remove the lens cap. P.32
REMOVE LENS CAP AND
PRESS PLAYBACK BUTTON. The camera does not start because the lens cap is still on
the camera. Remove the lens cap and press the 6
(playback) button or the POWER button to turn on the
camera. P.32