Radio Shack 32-2059 - Manual (Page 10)

18
The Basics
19
The Basics
caring for your equalizer
• Keep the equalizer dry. If it goes wet, wipe it dry
immediately.
• Use and store the equalizer only in normal
temperature environments.
• Handle the equalizer gently and carefully. Do not
drop it.
• Keep the equalizer away from dust and dirt.
• Wipe the equalizer with a soft cloth occasionally to
keep it looking new.
• Modifying or tampering with the equalizer's internal
components can cause a malfunction and might
invalidate its warranty.
FAQs
What do I do if my equalizer doesn’t seem to be working?
• Check the AC power connection and make sure the
AC outlet is “live.”
• Check the power connections to the rest of system
(amplifi er/receiver, input sources, and so on).
• Check the fuse. See "Replacing the Fuse" on Page **.
There’s no signal coming from one of my audio input
sources! What should I do?
• Check the equalizer’s and the source’s control
settings.
• Check the connection between the equalizer and input
source.
I hear a hum coming from the input source. How do I fi x
this?
• Make sure there are no low-level inputs connected to
the LINE input jacks.
product specifi cations
Equalizer Control Frequencies ........................... 25/40/63/100/
160/250/400/630/
1K/1.6K/2.5K/4K/
6.3K/10K/16K Hz
Equalizer Control Range ............................................ +/– 12dB
Input Sensitivity/Impedance .......................150mV/20K Ohms
Output Level (Level Max; EQ Flat) .............. 500mV/10k Ohms
Record Level (Level Max; EQ Flat) ............. 450mV/10k Ohms
S/N Ratio (A-WTD) ............................................................ 90dB
500mV OUTPUT T.H.D .......................................0.01% @1kHz
Frequency Response .......................... 10 Hz to 50 kHz +/-3dB
Channel Separation ..............................................70dB @1kHz
LED Level (500mV=0dB) ........................................0dB @1kHz
Low Cut ............................................................. –6dB @100 Hz
Power Source .................................... AC 120V, 60 Hz, 15-Watt
Power Fuse ..............................F 0.5 Amp, 250Volts Fast blow
Dimensions (HWD) ........................1 3/4 x 19 x 8 11/16 Inches
(44 x 480 x 220 mm)
Weight ...........................................................5.47 lbs (2.48kgs)
NOTE: Specifi cations are typical; individual units might vary. Specifi cations
are subject to change and improvement without notice.
NOTE: Actual product may vary from the images found in this document.