Radio Shack Auvio 16-906 - Manual (Page 7)

12
Basic Oper
ation
13
Advanced Operation
Zoom Mode
Auto: displays the picture as broadcast.
Wide: stretches the picture horizontally (will not remove black bars
built into some programs).
Zoom: zooms in to show only the center portion (removes black bars
on sides of some programs).
Cinema: zooms in to show center and stretches picture horizontally.
Restore Default Restores the factory settings.
Channel Setup (TV only)
Antenna Air (over the air) / CATV (cable): Reception method options.
Auto Scan Scan for channels. Erase previously saved channel information.
Auto Scan Add CH Scan for channels, but keep previously saved channel information.
Channel Skip (DTV
only)
Set the TV to skip specific channels found during autoscan.
Channel No (DTV
only)
Switch the channel, but remain in menu mode.
Channel Label
(DTV only)
Lets you edit the program label that appears when a channel is
selected.
Advanced Operation
Setting up Channels
You must scan for available analog and digital channels when you set up your TV. If you
do not scan for channels, the CH+ and CH– buttons will not function.
To scan for channels:
1. Press INPUT to select TV mode.
2. Press MENU and go to the Channel Setup page.
3. Select Auto Scan. The TV begins to scan for available channels. You can interrupt
the scan by pressing and holding MENU on the TV.
4. When the scan is complete, if you adjust the antenna, select Auto Scan Add CH to
add more channels to the scanned channel list.
5. Press MENU again to exit the setting menu.
n
Note: You can also access the Auto Scan menu by pressing AUTO on the
remote.