Radio Shack ET-899 - Manual (Page 2)

© 1999 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
MOUNTING THE PHONE
Desk Mounting
Wall Mounting
(With or Without Wall Plate)
USING THE PHONE
Switch to TONE or PULSE to match
the type of service you have. If you
have pulse (rotary) service, you can
switch to TONE during a call to use
tone services.
Note: If you do not subscribe to any special ser-
vices, pressing FLASH might disconnect the call.
Press FLASH to produce a timed switchhook sig-
nal for special services such as Call Waiting.
Press REDIAL to dial the
last number dialed (up to
31 tone or 32 pulse digits).
Press to hang up.
Plug the handset cord into
the jacks on the handset
and base.
Press RESET to end a call without returning the
handset to the cradle.
Press for special services.
Set RINGER to HI/LO/OFF for a
high- or low-volume ring, or to turn
off the ringer. You can make calls
with the ringer off, and you can
receive calls if you hear another
phone on the same line ringing.
This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C (RJ11W for a wall jack).
Modular
Telephone
Jack
Short
Line Cord
(supplied)