RCA J27F636 - Manual (Page 9)

Connections & Setup
Chapter 1 
Place all available Channels Into Memory
1. To go to the Setup menu, with the master remote (R130K2), press MENU
then select Auto Channel Search. In this menu you'll be able to set your
Signal Source. Choose from Analog, Digital or Both. This choice will depend
on what connections you've made to the ANTENNA/CABLE ANALOG
INPUT and/or the ANTENNA/CABLE DIGITAL INPUT jacks. Now set
your signal type. The TV will search for all channels viewable through your
antenna or cable TV system.
2. Scroll up to select which channel list you’d like to find channels for (List A is
the default).
3. Press the down arrow button to select Start. Press the OK button to start
searching. The TV searches for active channels and places them in the
channel list.
Note: Video Input Channels (VID, SVID, etc.) must be added to the
active channel list separately before they can be accessed. Refer
to the Setup menu section at the end of this chapter for more
information on the Channel menu and List & Labels.
Set the Time
The current time options might not be available to the basic user, depending on
how they've been set by the master user.
To set the time, from the Main menu select Time. If the current time has not been
set, use the arrow and number buttons on the remote control to set it.
1. From the Main menu, highlight Time and press OK.
2. Time is highlighted. To set the time, use the number buttons to set the hour.
Press the right and left arrow button to add or subtract minutes. The OK
button changes am and pm.
Note: The Wake-Up Timer and Wake-Up Time options are
unavailable unless Time has been set.
The ClonePRO™
If several TVs need to be programmed with the same menu settings, an optional
ClonePRO remote can be used to copy all of the menu settings from one TV into
other TVs to reduce installation time. Information can be both downloaded to
and uploaded from the ClonePRO using the DSCI port on the TV’s back panel
or using the IR sensor. A ClonePRO can be obtained from your RCA commercial
distributor. Chapter 2 has information about this remote, see page 20. If you
want to set other menu options before using the ClonePRO, continue on in this
chapter. You can use the ClonePRO at any time.
Go Back
Time 08:00 am
Time Access Basic
Sleep Timer Off
Wake-Up Timer
Wake-Up Time 07:00 am
Wake-Up Ch. 08
Schedule ...
TIME
AUTO CHANNEL SEARCH
Go Back
Channel List List A...
Signal Source Both...
Ana. Sig Type Cable...
Dig. Sig Type Antenna...
Start Running...
Progress 21%
Channel 012
Channels Found 16
The Master menus are available while
using the Master Remote (R130K2).