Ryobi TS1302 - Manual (Page 7)

Page 7
Fig. 1
Your Miter Saw has been shipped completely assembled
except for the blade, miter lock handle, dust guide or dust
bag, table extensions, and stop block.
■ Remove all loose parts from the carton. Separate and
check with the list of Loose Parts. See Figure 1.
■ Remove the packing materials from around your saw.
■ Carefully lift saw from the carton and place it on a level
work surface. Although small, this saw is heavy. To avoid
back injury, get help when needed.
■ Do not discard the packing materials until you have
carefully inspected the saw, identified all loose parts, and
satisfactorily operated your new saw.
■ Your saw has been shipped with the saw arm locked in
the down position. To release saw arm, push down on top
of saw arm and pull out the lock pin.
See Figure 3.
■ Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the lock pin.
■ Examine all parts to make sure no breakage or damage
has occurred during shipping.
If any parts are missing, do not attempt to assemble the miter
saw, plug in the power cord, or turn the switch on until the
missing parts are obtained and are installed correctly. Call
1-800-525-2579 in the United States or 1-800-265-6778 in
Canada for assistance if any parts are missing or damaged.
SAW BLADE
MITER
LOCK HANDLE
BLADE WRENCH
UNPACKING AND CHECKING CONTENTS
DUST GUIDE
DUST BAG
TABLE EXTENSION
STOP BLOCK
CLAMP
BRACKET SCREWS
SMALL
WING SCREW
CLAMP BRACKETS
TABLE EXTENSION
WARNING:
If any parts are missing do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious injury.
LOOSE PARTS LIST
The following items are included with your Miter Saw:
■ 10 in. (254 mm) Blade
■ Miter Lock Handle
■ Dust Bag
■ Dust Guide
■ Stop Block
■ Small Wing Screw (for use with stop block)
■ Table Extensions (2)
■ Clamp Bracket (2), (for use with table extensions)
■ Clamp Bracket Screw (2), (for use with table extensions)
■ Blade Wrench (1/4 in. Hex Key/Phillips Screwdriver)
■ Operator's Manual
■ Warranty Registration
Some models may include one or more of the following
accessories:
■ Work Clamp
■ 8 mm Work Clamp Screw