Rowe CD-100K - Manual (Page 26)

Section 2: Installation & Programming
21822666 2 - 1
Section 2: Installation & Programming
INTRODUCTION
This section describes the installation and programming process. This information begins with a summary of what
happens when the phonograph is powered up and continues with detailed instructions on how to load the titles and
discs, modify the pricing, and set up the sound system. The last part of this section describes how to make other
programming changes. (You can keep a record of the factory settings and your changes by using the Operator’s
Setup Sheet at the end of this section if you wish.)
POWER ON
WARNING
Do not plug the phonograph in until you verify it is configured for the proper mains voltage.
The phonograph is factory configured for 120 AC (~) mains voltage.
For 220 to 240 mains voltage, remove the 120 ~ Mains Supply Voltage Selector plug from the 61145001
Main Power Supply, and install the 240 ~ Main Supply Voltage Selector plug.
The 240 ~ Mains Supply Voltage Selector plug is factory shipped in the coin cash bag.
BLACK
WHITE
WHITE
BLACK
1
2
3
4
120~
MAINS
SUPPLY
VOLTAGE
SELECTOR
BLUE
BLUE
1
2
3
4
240~
MAINS
SUPPLY
VOLTAGE
SELECTOR