Radio Shack 33-3001 User Manual

Uni-directional dynamic microphone, What’s included step three, Step one step two

Advertising
background image

Uni-Directional
Dynamic Microphone

33-3001

A

What’s Included

Step Three

Operation

1. Plug your microphone’s 3-pin (XLR) plug

into the corresponding end of the supplied
cord. To prevent feedback, be sure the
microphone is turned off before connecting
it to a PA or recording system.

2. Plug the cord’s other end (

1

/

4

-inch plug) into

the microphone jack of your PA or
recording system.

3. Turn on your PA or recording system.

4. Set the microphone’s ON/OFF switch to

ON. When you finish using the
microphone, set ON/OFF to OFF.

Using the Microphone Holder

To use the supplied microphone holder with
your microphone, screw the holder down onto
the top of a microphone stand. Then slide the
microphone into the larger end of the holder
until it is secure.

Step One

Step Two

Microphone

ON/OFF

©2003. RadioShack Corporation. 33-3001
All Rights Reserved.

Printed in Taiwan

RadioShack and RadioShack.com are trademarks

06A03

used by RadioShack Corporation.

This product is warranted by RadioShack against manufacturing defects in material and workmanship under nor-
mal use for 90 days from the date of purchase from RadioShack company-owned stores and authorized
RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS
WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED
WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABIL-
ITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY
LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO,
ANY DAMAGES RESULTING FROM INCONVENIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR
PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of inciden-
tal or consequential damages, so the above limitations or exclusions may not apply to you.

In the event of a product defect during the warranty period, take the product and the RadioShack sales receipt as
proof of purchase date to any RadioShack store. RadioShack will, at its option, unless otherwise provided by law:
(a) correct the defect by product repair without charge for parts and labor; (b) replace the product with one of the
same or similar design; or (c) refund the purchase price. All replaced parts and products, and products on which a
refund is made, become the property of RadioShack. New or reconditioned parts and products may be used in the
performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the expiration of
the warranty period.

This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse, accident, mis-
use, improper or abnormal usage, failure to follow instructions, improper installation or maintenance, alteration,
lightning or other incidence of excess voltage or current; (b) any repairs other than those provided by a
RadioShack Authorized Service Facility; (c) consumables such as fuses or batteries; (d) cosmetic damage; (e)
transportation, shipping or insurance costs; or (f) costs of product removal, installation, set-up service adjustment
or reinstallation.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state

RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102

12/99

Limited 90-Day Warranty

Internal Connections

Frequency Response Curve

Mic Unit

Yellow

Yellow

Green

A3M (Type)

Microphone Holder

Red

Red

Type ................................................. Dynamic
Directivity ................................. Unidirectional
Impedance ......................... 500 Ohms ± 30%
Sensitivity (at 1 kHz) ................. –72dB ± 3dB
Frequency Response .............. 50–16,000 Hz
Cable (Length

×

Diameter) .......... 16 ft

×

1

/

4

in

(4.87 m

×

6.35 mm)

Plug .............................

1

/

4

-in (6.35mm) Phono

XLR Connector (Cable Connection)

Included Accessory ......... Microphone Holder
Weight (excluding cable)....................... 9.8 oz

(280g)

Specifications are typical; individual units might
vary. Specifications are subject to change and
improvement without notice.

Specifications

Advertising