Radio Shack 26-137 - Manual

Illuminated USB 2.0
4-Port Hub
26-137
Thank you for purchasing the RadioShack Illuminated USB 2.0 4-Port Hub.
You can connect and power up to four peripheral USB devices, and the ports
light up when power is connected. The hub’s transmission rate is 40 times
faster than USB 1.1, meaning it can support devices that require high speed
transmissions, such as scanners, DVD drives, digital cameras, and others.
In order to reach USB 2.0 speed, your computer or host adapter card must
have USB 2.0 support. The hub is also backwards compatible with USB 1.1.
System Requirements
• Windows 98SE/ME/2000/XP
• PC or notebook with Pentium 233 MMX or higher and one available
USB port
• At least 64 MB RAM
1. Plug the AC adapter's barrel plug into the
hub’s 5V 2.4A jack, and plug the other
end into a standard AC outlet.
2. Plug the USB cable's mini A-type connector
into the hub’s host port.
3. Plug the USB cable's A-type connector into your PC's host port or
upper level hub. Hub installation starts automatically. If not, follow
the instructions that appear on your computer screen to manually
complete installation.
4. To verify installation, click on Start/Settings/Control Panel/
System on your computer.
5. Select the Hardware tab, and then click Device Manager.
6. Select Universal Serial Bus controllers from the list that
appears. All connected USB devices are listed.
7. Select Generic USB Hub. The Generic USB
Properties screen appears with this message,
"This device is working properly." Receipt of
this message indicates successful hub
installation.
Introduction
Installation
USB 2.0 Cable
4-Port Hub
AC/DC Power Adapter
Narrow end connects
to your PC.
Wide end connects
to your 4-port hub.