Radio Shack ACCURIAN 40-1462 - Manual (Page 2)

©2004 RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation. 15-1938 /15-1937
40-1462
07A04
Printed in Taiwan
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult your local RadioShack store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your
equipment. Changes or modifi cations not expressly approved by RadioShack may
cause interference and void the user’s authority to operate the equipment.
Sender
Power Source .......................................................120VAC 60Hz
Transmission Range ......................................................300 feet
Low Audio Input Level ................................................... 470mV
High Audio Input Level ................................................. 1100mV
Audio Input Impedance ............................................. 10k Ohms
Receiver / Amplifi er
Audio Output ............................................... 25W RMS/Channel
Ports ..............................................8 Ohms Output Terminal x 2
Frequency Response ............................................50Hz – 20kHz
S/N Ratio ......................................................................... >50 dB
Stereo Separation .......................................................... >45 dB
Speakers
Speaker Complement ............................. 5” Woofer, 1” Tweeter
Frequency Response ............................................ 50Hz – 20kHz
Power Handling ................... 25W RMS/50W Max (per channel)
Nominal Impedance ....................................................... 8 Ohms
Sensitivity .................................................. 83dB SPL (at 2V 1W)
Crossover Frequency ........................................................ 10kHz
Specifi cations are typical; individual units might vary. Specifi cations are
subject to change and improvement without notice. Actual product may
vary from the product images in this document.
This product is warranted by RadioShack against manufacturing defects in material and
workmanship under normal use for ninety (90) days from the date of purchase from
RadioShack company-owned stores and authorized RadioShack franchisees and dealers. For
complete warranty details and exclusions, check with your local RadioShack store.
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04
• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifi ers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fi t into your outlet, consult an
electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories specifi ed by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specifi ed by the
manufacturer, or sold with the apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for a long periods of
time.
• Refer all servicing to qualifi ed service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have been fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.
• Use only with the cart, stand, tripod, bracket, or table specifi ed by the
manufacturer or sold with the apparatus. Be careful when using the
cart and apparatus to avoid injury from tipping over.
KEEP THESE INSTRUCTIONS
Product
Networked Home
Entertainment System
Models
15-1937 • 15-1938
40-1462
Responsible Party
RadioShack
100 Throckmorton
Fort Worth, TX 76102
Phone 817-415-3200
Keep the networked home entertainment system dry. If it gets wet,
wipe it dry immediately. Use and store it only in room temperature
environments. Handle it carefully. Do not drop it. Keep the system away
from dust and dirt, and wipe it with a damp cloth occasionally to keep it
looking new.
If your system is not performing as it should, take it to your local
RadioShack store for assistance. To locate your nearest RadioShack,
use the store locator feature on RadioShack’s website (www.radioshack.
com), or call
1-800-The Shack (843-7422) and follow the menu options. Modifying
or tampering with the system’s internal components can cause a
malfunction and might invalidate its warranty and void your FCC
authorization to operate it.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
1. Rotate VOLUME on each receiver counterclockwise to adjust the
volume to its lowest sound level.
2. Press POWER on each of the individual devices comprising the
networked entertainment system to turn them on.
3. Turn on the audio source connected to the sender.
4. Adjust VOLUME on each receiver to set a comfortable listening
level.
5. Rotate BALANCE clockwise to decrease the left speaker’s volume
sound, and counterclockwise to decrease the right speaker’s
volume sound.
6. Rotate BASS clockwise to increase, or counterclockwise to
decrease bass sound.
7. Rotate TREBLE clockwise to increase, or counterclockwise to
decrease the high frequency sound.
8. To turn off the individual devices, press POWER on each one.
POWER VOLUME BALANCE BASS TREBLE
VOLUME
BALANCE
BASS
TREBLE POWER
How does the system send audio without wires?
The sender converts the audio signal to a 4.3 – 20.9MHz carrier frequency,
then sends it through your home power line to a receiver that converts it
back to its original form, and then sends it to the amplifi er and speakers.
Why won’t my system work?
• Make sure each AC power cord connects to the system device and wall
outlet securely.
• Make sure the devices are plugged directly into a wall outlet. Do not use
a power strip or any other adapter.
Why don’t I hear any sound from the system?
• Be sure your sender and receivers are turned on.
• Be sure all wires are connected securely.
• Be sure the audio source is turned on.
• Adjust the receiver’s volume control.
• Be sure the amplifi ed speaker system is placed within the sender’s 300-
foot transmission range.
• Check power connector and fuse if speaker power indicator is not light,
How can I correct for distorted sound?
Reduce the audio source’s volume. Make sure your sender’s Audio Input
Level is set to High.
How can I correct for popping noises or drop outs in the sound?
• Relocate your sender. Your amplifi ed speaker system must be within 300
feet of the sender.
• Try another outlet. Some outlets may have excessive noise from
switching devices that your Home Plug can’t overcome.
• While using Home Plug, turn off compact fl uorescent lights, halogen
lights and other devices that may cause interference.
How can I increase my output volume?
To boost your volume, set the sender’s Audio Input Level to Low.
How many speakers / receivers can I connect?
Although you can only connect one transmitter, under some conditions you
may be able to connect up to 4 or more receivers and speakers.
Can I use this system with other HomePlug or Plug ‘n Power products?
Your HomePlug audio system is compatible with other HomePlug products.
While there are bandwidth limitations, you should not experience problems,
unless you have more than 16 HomePlug devices on the powerline or
you have noisy electronics on the power line. Plug ‘n Power operates in
different bands than HomePlug and shouldn’t create interference.
1. To remove the fuseholder on the speaker or receiver/amplifi er, use
a small screwdriver to unclip the fuseholder compartment, and
then slide it out.
2. Replace the fuse with a fuse of the same size and capacity.
3. Push the fuseholder compartment back in until it snaps into place .
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER
OR BACK. NO USER-SERICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
WARNING: To reduce the
risk of fi re or shock hazard,
do not expose this product to
rain or moisture CAUTION
! RISK OF ELECTRIC SHOCK
DO NOT OPEN
40-1462
15-1937
Fuseholder
compartment
The lightning symbol is intended to alert you to the presence of uninsulated,
dangerous voltage within this product’s enclosure that might be of suffi cient
magnitude to constitute a risk of electric shock. Do not open the product’s
case.
The exclamation symbol is intended to inform you that important operating
and maintenance instructions are included in the literature accompanying
this product.
!
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.