Raymarine Ray230 - Manual (Page 94)

3-71 Operations
3.5.30.5 Setting Operation (RAY230E)
This operation sets the function features of the RAY230E: the name of the
Intercom station, the ATIS ID number and on/off state, the MMSI number,
the Tri-Watch function, and the call tone type of the siren.
1. Press the FUNC key followed by the MENU key to initiate the Menu
mode. Mn is shown on the 7-segment display and NAVSTAT appears
on the dot matrix display.
2. Press the SQ UP/DOWN key to select SETTING.
3. Press the ENT key. The message SET appears on the 7-segment display
and INTERCM appears on the dot matrix display. Pressing the SQ UP/
DOWN key alternates between the following:
INTRCM selects the Intercom setting
MY ATIS registers the ATIS ID number
MY MMSI registers the MMSI number
TRI
selects the Tri-Watch operation
ATIS turns the ATIS function ON or OFF
SIREN selects the siren setting
Note: The ATIS selection only appears if this option has been enabled
by the dealer.
4. Select the desired operation and press the ENT key to submit your
selection.
ENT