Runco LIGHTSTYLE LS-10I - Manual (Page 79)

Operation
Runco LS-10i Installation/Operation Manual 63
PRE
L
IMINAR
Y
Input Enable: To enable or disable selection of a source, choose Input Enable from the
System menu and press ENTER. This displays the Input Enable sub-menu, shown in
Figure 4-14.
Figure 4-14. Input Enable Sub-Menu
• HDMI 1/HDMI 2: Enables or disables the HDMI 1 and HDMI 2 sources.
• RGB: Enables or disables the RGB source.
• Comp 1/Comp 2: Enables or disables the Component 1 and Component 2 sources.
• Video: Enables or disables the Composite video source.
• S-Video: Enables or disables the S-Video source.
• SCART: Enables or disables the SCART RGBS source.
If either Component 1 or Video is enabled, SCART must be disabled.
If SCART is enabled, both Component 1 and Video must be disabled.
Note
Note