RAD Data comm ASMi-52 - Manual (Page 158)

Appendix B IR-IP Interface Module Installation and Operation Manual
B-22 Using the Device Control Menu ASMi-52 Ver. 2.5
Erasing Configuration
Selecting Erase Configuration allows you to reset all the configuration parameters
to their default values.
• Do this only if you need to reconfigure the module anew (all the parameters).
• After erase confirmation all connections with the IR-IP module will be lost. For
instructions on further configuration, refer to Performing Preliminary
Configuration on page B-6.
Resetting IR-IP
The Reset menu allows you to perform reset of IR-IP, or its interfaces.
This operation can be used to restore normal operation after service is disrupted
by an abnormal condition. Any data stored in the IR-IP buffers is discarded, and
the flow of traffic is temporarily interrupted.
IR_IP <IR-IP> S/W Ver. 1.21 (date)
Quick Setup
Management Access
Advanced Setup
Device Control
.....................................................................
New Software Download
View error LOG
Resets
=====================================================================
1. Reset Device
2. Reset LAN
3. Reset WAN
Press one of the numbers to select or ESC:
Figure B-17. Resets Menu
To restart IR-IP:
• From the Device Control menu, select Resets. From the Resets menu, type 1.
You will be prompted to confirm the reset operation.
Resetting the device will restart the IR-IP interface module, and therefore traffic flow
is temporarily interrupted, and the Telnet connection is lost.
Reset LAN
To reset the LAN interface:
• From the Resets menu, select Reset LAN.
You will be prompted to confirm the reset operation.
Note
Note