Maintenance – RedMax LRTZ2500 User Manual
Page 19
19
9. Maintenance
■ BLADES (MA1)
• When refilling the tank or resting, it is often a
good idea to use the time to oil the cutting
blades.
• If a gap exists between the upper and lower
blades, follow the procedure below to adjust
them so that they fit more closely together.
1. Loosen lock nut (A) as shown in the diagram.
2. Tighten screw (B) fully, and then turn one-third
to one-half of a rotation backward.
3. While holding onto the screw to keep it in
position, tighten the lock nut.
4. Check to make sure that the flat washer (C) is
loose enough so that it may be turned by
pressing on it with a finger.
(1) Upper blade
(2) Lower blade
Screwing in the screw too tightly may make it
impossible for the blades to move. Conversely, not
screwing in the screw tightly enough may make the
blades of the trimmer feel dull and cause leaves
and branches to become caught in the blades of
the trimmer.
NOTE
MA1
every every every
25
50
100
system/compornent
procedure
before hours hours hours
note
use
after
after
after
fuel leaks, fuel spillage
wipe out
✔
fuel tank, air filter, fuel filter
inspect/clean
✔
✔
replace, if necessary
see
■ADJUSTING
replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.17)
if necessary
clean and readjust
GAP: .025in(0.6~0.7mm)
spark plug
✔
plug gap
replace, if necessary
cylinder fins, intake air cooling vent clean
✔
muffler, spark arrester, cylinder exhaust port clean
✔
throttle lever, ignition switch
check operation
✔
replace if
cutting parts
✔
something's wrong
gear case
grease
✔
screws/nuts/bolts
tighten/replace
✔
✔
not adjusting screws
ENGINE
SHAFT
■ MAINTENANCE CHART