RAD Data comm AMC-101 - Manual (Page 28)

Chapter 2 - Installation & Setup AMC-101 Installation & Operation Manual
2-4 AMC-101 Modules
Figure 2-5 Installation of Two Units (b)
2.3 Cable Connections
AC Power
Connection AC power should be supplied to AMC-101 through a 1.5m (5 ft) standard
power cord terminated by a grounded 3-wire plug.
Warning
When applying AC power, first connect the plug of the AC cable to the
power connector on the rear panel of AMC-101 and then to the mains
outlet.
Grounding
Warning
Interrupting of the protective (grounding) conductor (inside or outside
the instrument) or disconnecting the protective earth terminal can make
this instrument dangerous. Intentional interruption of the grounding
conductor is prohibited.