Sylvania SRCD427P - Manual (Page 19)

- 19 - EN
1C29
TV OPERATION
DEGAUSSING
Magnetism from nearby appliances and unshielded
speaker systems might affect the color of the TV pic-
ture.
If this happens, move this unit away from the appli-
ance. If the color is still not correct, unplug the power
cord, then plug it in again 30 minutes later.
TV/VCR
WATCHING A TV PROGRAM
1 Turn on the unit
Press the POWER button to turn on the unit.
2
Select the channel number
Press the CHANNEL button K or L to select your
desired channel number or press the number on the
remote control.
Note for using the Number button on the remote
control:
¡ You must precede single-digit channel numbers
with a zero (For example: 02, 03, 04 and so on).
¡ When selecting cable channels which are higher
than 99, press +100 first, then press the last two
digits. (Example: to select channel 125, first press
“+100” then press “2” and “5”).
Remember: If the unit is connected to a cable box or
satellite box, it must be on CH3 or CH4, then the
channel to be viewed must be selected on the cable
box or satellite box.
3 Adjust sound
Press the VOLUME button X X or Y Y
to adjust the volume.
NOTES:
• If you press the CHANNEL button K or L in the
DVD mode, you can change the TV channels.
Even if you turn off the unit in the DVD mode,
when you turn it on again, it will go into the
TV/VCR mode.
TV/VCR
PICTURE CONTROL
The unit’s picture controls – BRIGHT, CON-
TRAST, COLOR, TINT and SHARPNESS – are
preset to factory specifications. Although they are
usually the best, you may need to make some further
adjustments for your individual preference.
NOTES:
• Procedures must be followed within 5 seconds or
the Picture Control mode will be cancelled.
• When setting the Picture Control, the Game mode
will be cancelled.
Make sure ...
• The unit is turned on.
1 Select “PICTURE CONTROL”
Press the PICTURE button on the remote control.
2
Select item you want to adjust
Press the Arrow button K or L until desired control
is displayed.
BRIGHT
CONTRAST
COLOR
TINT
SHARPNESS
3 Adjust the picture control
Press the Arrow button s or B to adjust to your
desired level.
TV/VCR
• If there is a power failure of any kind, the unit will
remember the setting.
VOLUME 20
C C C C C C C C C C C C
BRIGHT
– P P P P P P P P P P P P P P C C P P P P P P P P P P P P P P +
to decrease
brightness
to decrease
contrast
to pale to brilliant
to green
to clear
to purple
to soft
to increase
brightness
to increase
contrast
BRIGHT
CONTRAST
COLOR
TINT
SHAPNESS
Arrow Button { Arrow Button B
T2005UF(p1-35).QX3 04.4.27 7:55 PM Page 19