Ohlins FG 012 - Manual (Page 10)

10
Dismantling
10
Perform steps 4-7 "Changing
springs" on page 9.
Loosen the bush head, on top of the
cartridge tube, with tool 1797-01.
Lift up the damper rod assembly
and drain the oil.
Pull up the scraper with a screw-
driver, release and remove the circlip.
11
CAUTION!
The fork legs have two fixed and
one sliding bushing. Be very care-
ful when disassembling the fork
legs.
Fasten the fork leg horizontally with
soft jaws in a vice.
Use a hot air gun to warm up the
outer leg where the bushings are
located.
The first bushings is located at the
bottom end of the outer leg, the sec-
ond approximately 150 mm further
up the leg.
Between them is a sleeve to main-
tain the distance.
12
Use the special tool 1702-02 to
remove the bushings.
Install the tool in the top of the in-
ner steel leg.
Screw the top cap onto the tool and
install the cap in the outer leg.
Rotate the tool to press out the
bushings.
If tool 1702-02 not is avaliable push
the inner steel leg to the bottom and
then pull it back quickly, so that the
fork is topping out hard.
Repeat this procedure until the seal
and the bushings can be pulled out
from the outer leg.
1702-02
15o mm
1797-01
10
11
12
13
14
15