Optoma Single Chip DLP Projector - Manual (Page 10)

10
E
nglish
Lens cap
Power / Standby
Installation
Powering On the Projector
1. Remove the lens cap.Œ
2. Ensure that the power cord and signal cable are securely
connected.
3. Turn on the lamp by pressing “Power/Standby” button on
the control panel. 
The startup screen will be displayed for 20 seconds and the
Power/Standby indicator will light solid green.
4. Turn on your source (computer, notebook, or video player ,
etc...) The projector will detect your source automatically.
v If the screen displays “No Signal” , please make sure the signal
cables are securely connected.
v If you connect multiple sources at the same time, use the “Source”
button on the Remote Control or Panel Control to switch.
Powering On/Off the Projector
v Turn on the projector
first and then the
computer.
1
2