Olympus FMD-250W - Manual (Page 15)

E-15
ENGLISH
Holding the tips of the frame
arms, gently move them apart
to put the display unit on.
Caution:
Do not hold the hinges. Doing so
may disengage the arms.
Remove each headphone upward from the holder as
shown in the figure.
●
When putting the headphones back in the holders, simply
reverse the order of removal for each.
●
If you wish to use ear pads on the headphones, use 16.0 mm
ear pads (commercially available).
Wearing the display unit
1
Put the display unit on as if
wearing glasses and insert
the headphones.
●
Adjust the nose pad to put the
image to the optimal position. If
this adjustment is not performed,
the image may appear dim.
●
If the image still cannot be seen
properly or is dim after adjusting
the nose pad, switch the left
and right frames (
੬
pg. 28).
●
When wearing the display unit
over glasses, pull the nose pad
out slightly more than usual.
● If you cannot wear the display
unit securely because there is
too much space between the
frame arms, reduce the space
using the frame arm adjusters
(
੬
pg. 16).
2
●
Be sure to wear the display unit properly so that the image appears clear and stable in both eyes.
●
If you widen the frame arms too much when wearing the display unit, the frame adjusters may pop
out.
●
Do not pull or twist the nose pad excessively in directions other than those shown in the figure. This
may break the nose pad or crack its surface.
WEARING/REMOVING THE DISPLAY UNIT
NOTICE
Headphones
Nose pad
Nose pad