One for All SV-9530 - Manual (Page 4)

2 WWW.ONEFORALL.COM
Thank you for purchasing the ONE FOR ALL Signal Amplifier. ONE FOR ALL continuously strives to develop,
produce and market high-quality innovative products to meet your needs. We hope this Signal Amplifier
will give you total satisfaction.
The ONE FOR ALL Signal Amplifier is designed to boost the signals of your antenna or cable box, this allows
you to distribute the signal to multiple devices and/or use longer cable/cables without losing picture and
sound quality.
Below you’ll find the description of your ONE FOR ALL Signal Amplifier (see picture 1).
a: Power plug
B: Signal input
C: Signal outputs
D: Gain Variance Knob
e: 1 meter of co-ax cable
To connect your ONE FOR ALL Signal Amplifier, please follow the steps below.
• 1 Connect your TV(s) or other devices to the signal outputs (C 1-3)
• 2 Connect your antenna/cable box or other devices (see picture 3) to the input (B) on the
ONE FOR ALL Signal Amplifier using the 1 meter co-ax cable (E).
• 3 Plug the ONE FOR ALL Signal Amplifier into the mains.
As situations vary, please find some different examples of use (pictures 2 – 5):
An antenna is connected to the ONE FOR ALL Signal Amplifier. The signal will be boosted
and distributed to up to 3 TV’s.
An antenna is connected to the Satellite receiver which is connected to the VCR. The VCR is
connected with the 1 meter co-ax cable to the ONE FOR ALL Signal Amplifier. The signal will be
boosted and distributed to up to 3 TV’s.
A cable box is connected to the ONE FOR ALL Signal Amplifier. The signal will be boosted
and distributed to up to 3 TV’s.
A FM antenna is connected to the ONE FOR ALL Signal Amplifier which will boost the signal
and distribute it to up to 3 radio tuners.
(*) It may be possible that you have to use inline co-ax-connectors to make the connections. (See
picture)
It is possible that the signal gets over amplified. The result will be that the picture and sound is not clear.
Turning the Gain Variance Knob (D) to the left or right will allow you to increase or decrease the signal’s
gain.
• If the incoming signal is unclear, the ONE FOR ALL Signal Amplifier will not improve your picture as it will
also amplify the noise in the signal. Please contact your antenna or satellite installer for further details.
• If the signal gets over amplified turn the Gain Variance Knob (D) to the right and then slowly to the left
and see if the picture improves.
• Check all the connections. Loose or bad connections will result in an unclear picture.
note:
uK products will be supplied with a uK 3 pin power plug.
thanK You
the proDuCt
helpful hIntS
GaIn VarIanCe
1
ConneCtInG the SIGnal aMplIfIer
2
3
4
5
English
706082_SV-9530_17t:Amplifier SV-9530 11 talen 6’99 15-05-2007 15:46 Pagina 2