Oreck XL2090RHM - Manual (Page 4)

3
1
2
3
4
9
10
11
14 15
12
13
5
6
7 8
16
Warranty
ORECK MANUFACTURING COMPANY: (Oreck gives you the following
limited warranty for this product only if it was originally purchased for
use, not resale, from Oreck or an Oreck Authorized Retail Dealer.)
Oreck will repair or replace, free of charge, to the original purchaser,
any part which is found to be defective in material or workmanship
within six (6) months of the date of purchase. This limited warranty
covers the revolving roller brush for thirty (30) days for commercial use
only.
This limited warranty does not cover the replacement of expendable or
consumable parts such as carbon motor brushes, edge brushes, drive
belts, bulbs, disposable bags and other parts subject to normal wear
unless they are defective in material or workmanship.
This limited warranty does not apply to any part subjected to accident,
abuse, or alteration, misuse, damage caused by fire or act of God, the
use of voltages other than indicated on the serial number plate of this
product or service of this product by other than Oreck or an Oreck
Factory Authorized Service Center.
Oreck does not authorize any person or representative to assume or
grant any other warranty obligation with the sale of this product.
Oreck’s limited warranty is valid only if you retain proof of purchase
from Oreck or an Oreck Authorized Retail Dealer for this product. If you
purchase this product from any other source, your purchase is “AS IS,”
which means Oreck grants you no warranty, and that you, not Oreck,
assume the entire risk of the quality and performance of this product,
including the entire cost of any necessary servicing or repairs of any
defects.
Oreck’s liability for damages to you for any costs whatsoever arising out
of this statement of limited warranty shall be limited to the amount paid
for this product at the time of original purchase, and Oreck shall not be
liable for any direct, indirect, consequential or incidental damages
arising out of the use or inability to use this product.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not
apply to you.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT,
INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE WARRANTY PERIOD, AND NO WARRANTIES,
WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THIS
PERIOD.
Some states do not allow limitations on the duration of implied
warranties, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
Unit Specifications
Power head: Width 12 1/2”, Height 4”, Leading Edge 2 1/2”.
Self-adjusting to carpets and bare floors. Includes patented edge
cleaning device.
Motor: High performance precision motor, sealed ball bearing on solid
shaft. High temperature insulation, factory lubricated for life. Heat
dispersion system and motor cooling fan device, with self-cleaning
blades.
Electrical: 120 volts A.C., 4 amps, 480 watts, 60 Hz.
Power cable: 35 feet long, Three conductor SJT type. Flexible heavy
duty jacket.
Sealing gaskets: Cover plate sealing gaskets absorb shock, insulate,
resist corrosive chemicals and abrasive contact. Provide effective seal
against dust and suction loss.
Agitation: Full intersecting dual-row sharp helix pattern nylon bristle
brush rotates on lifetime lubricated ball bearings. High speed alternating
action brush cleans at approximately 6,500 rpm. Bearing holders may
be rotated 1/2 turn to extend bristle life. Dirt seals protect brush
bearings from dirt build-up.
Drive belt: Most trouble-free because it’s sealed off from the dirt
collection area. Eliminates “center” dirt path. Motor drive shaft is
hi-carbon, stress proof steel, ground finish for minimum belt wear. Spare
belt is stored in baseplate.
Super filter bag: 736 cubic inch capacity. Hypo-allergenic version is
CELOC
® Hypo-Allergenic multi-layered, high dust retention, disposable
filter bag.
Bag Cover: XL Filter Knit, heavy duty, reinforced. Convenient pocket in
back for storage of cleaning accessories and extra disposable dust bag.
MicroSweep
® : Cleans bare floors without hoses, adjustments, or
attachments.
Parts List
To assist you in identifying components of your vacuum, the parts have
been numbered as follows:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop / cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
16 Handle brace
Assembly
fig. 1 Before assembling appliance, remove two screws from
connector assembly. Remove cardboard insert by pulling
upward.
fig. 2 With ON/OFF switch facing the front of the unit, slide upper
handle section over matching section of the connector assembly.
Place brace against handle and connector assembly aligning
screw holes. Insert short screw into top hole and long screw into
the bottom hole then tighten firmly until handle is no longer
loose.
fig. 3 Attach cord to cord clip by pressing cord above and below clip
ensuring the cord is fully rested in clip.
Operating Instructions
Make sure disposable paper filter dust bag is in place. DO NOT operate
the cleaner without a paper filter dust bag. Plug the power cord into an
electrical outlet and press the
On (l) - OFF(O) switch on Helping Handle
Assembly when ready to operate.
Up-Position Lock
fig. 4 Place foot on power head and lean handle back gently to release
lock for vacuum use. Return handle to the full upright position to
engage lock.
NOTE: Do not operate the unit while in the upright and locked position.
Do not let the unit run while in any one stationary position for any period
of time. Keep the unit moving while in operation.
Operating Recommendations
This new ORECK XL High Speed Upright is one of the finest, fastest,
and strongest units in its class. You’ll love the way it cleans, gets under
things, and it’s SO lightweight and easy to use.
The following are a few simple suggestions regarding its operation:
1. When inserting a new disposable paper filter dust bag—FIRST
PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or makes an
unusual noise, STOP OPERATION and service.