Olympus C-200 Zoom EN - Manual (Page 28)

18
Turning the Power On
1
Slide the lens barrier open
until it clicks.
• This turns the power on in
shooting mode.
• The lens extends and the flash
pops up.
• The monitor displays the
information shown at left.
• After a short time, the monitor
will go off.
• If the card cover is not
securely closed, the power is
not turned on even if the lens
barrier is opened.
• To turn off the power, see
“Turning the Power Off” (p.34).
Standby mode
If the lens barrier is left open and nothing is operated after three
minutes, the camera goes into standby mode. In this energy saving
mode, even if the monitor is illuminated, it will automatically go off. To
resume shooting take one of the following procedures.
• Lightly press the shutter button or zoom lever.
• Close (p.34) and then open the lens barrier.
• Press any button on the arrow pad, the OK button, the menu button or
the monitor button.
In the standby mode, the camera will turn off completely after about 4
hours of not being used. When using new batteries, it may take longer
for the camera to shut down automatically, depending on the type of
batteries being used. To extend battery life, turn the camera off
whenever you do not intend to be taking pictures for a while.
CAUTION
• Never open the card compartment cover, remove the card or batteries, or
disconnect the AC adapter while the camera is in operation as this could
result in damage to the data stored on the card.
HQ
Record mode Battery check
Monitor
Slide the lens barrier open.