Olympus C-200 Zoom EN - Manual (Page 74)

Using the Flash
Switching Between Flash Modes
Select the appropriate flash mode according to the shooting conditions.
Note that the flash will not operate when shooting sequential shots
(p.57), shooting movie pictures (p.60) and taking panoramic shots (p.82).
Also, the working range of the flash changes when you operate the
zoom lever (p.30).
The camera is automatically set to auto-flash mode when the power is
turned on. Changing the flash mode to other settings will cause the
flash mode mark to be displayed on the monitor.
1
Open the lens barrier.
• The camera turns on in
shooting mode.
2
Press
୴ ( ) on the arrow
pad.
• The monitor will illuminate and
one of the flash mode marks
shown in the table below will
be displayed.
• Each time you press
୴ the
flash mode will change to the
next mode shown in the table
below.
3
Press
୴ on the arrow pad
several times until the symbol
for the flash mode you want
to use is displayed on the
monitor.
See the table on the following page
for a description of the various
possible flash modes.
64
2 3
HQ
Monitor
Flash mode mark
(Displayed except
auto-flash mode)