Opticon LMD 1135 - Manual (Page 56)

Manual No. 25-ULPNR102-01; Mar, 2005 LMD 1135 Laser Fixed Mount Scanner
Page 52
22. Code Identification & Characters/Digits Transmitted
This feature instructs the scanner to use pre-existing code identifiers and/or to calculate/transmit a
number indicating the total number of characters that are being transmitted to the host for specific
symbologies. This feature allows the host to verify that the correct amount of data was received. This
information may be transmitted as either a prefix or suffix.
Code identification using the pre-existing symbology codes can be accomplished using the “Code
identification” command as shown in the example below.
Code length is transmitted as 2 or 6 digits depending upon the selection made from the menu below.
These commands can be used together or individually as required.
Computer
Command
Function
/Description
Bar Code
Command
(ZZ)
START/END
Programming Menu
[[
$2 Code identification
%3
$3
Enable code length
2 digits
%!
$6
Enable code length
6 digits
%7
6A Direct Input Character ”:”
7B
Example: To set a prefix for “<code identification>:<code length>:” scan the following menu items:
< START/END> Menu below
<Set Prefix All Codes> Section 15 (or specific symbology)
<Enable Code Identification> Menu below ($2)
<:> Menu below (6A)
<Enable Code Length 2 or 6> Menu below ($3) or ($6)
<:> Menu below (6A)
<START/END> Menu below