Omega DP119-RTD - Manual (Page 21)

14
3.5 Analog Output Connections
The analog output is a linearized millivolt signal that is equivalent
to the displayed temperature. It comes as a standard feature
with every unit. The resolution of the analog output is no greater
than the resolution of the display.
The analog output is a non-isolated signal.
To access the analog signal, attach copper wire to the 3-pin
female connector that is supplied with the meter. Refer to
Figure 3-9 for wiring instructions. Plug the female connector into
the P2 (male) connector at the rear of the meter.
Figure 2-2 shows the location of the P2 connector on the meter.
Note that this connector shares a common return with the
ÒDisplay Hold" function.
Figure 3-9. Analog Output Connections (P2)
1
2
3
RETURN
Screws
underneath
Output +
mV
–
Note ☞