Oregon Scientific PMR RADIO TRANSCEIVER TP380 - Manual (Page 11)

11
Roger Beep Enable/disable beep heard after the
finish of a received transmission
Key Tone Enable/disable beep when a key on the
transceiver is pressed
Vibrating Enable/disable vibration function
Automatic Enable/disable automatic shut-off after
Power-Off device is idle for 2 hours
NOTE: Press MENU to confirm and move to the next setting. To confirm
the changes but quit the Menu Options, press PTT.
SELECTING A CHANNEL
Select between 8 channels. The transmitter and receiver must be on the
same channel.
1. Press MENU once until the channel number starts flashing on the
LCD.
2. Press and hold or to begin scanning a channel. If a valid signal
is present, the transceiver will pause on the current active channel.
3. Press PTT to stop scanning and exit the menu. Or, press MENU to stop
scanning and go to the next Menu Option.
CTCSS SCANNING
You can activate the channel scan function:
1. Press MENU twice until the CTCSS number starts flashing on the
LCD.
EN