Sylvania DVC860E - Manual (Page 5)

– 5 – EN
Setup
Setup
If you cannot play back a disc which bears one of the marks above, check the following notes.
*1: This unit conforms to the NTSC color system. Discs recorded in other color systems such as PAL or SECAM
cannot be played back.
*2: Certain DVD-Video discs do not operate as described in this manual due to the intentions of the discs’ producers.
*3: Only the discs which have been recorded in the video format and finalized can be played back.
Discs unfinalized or recorded in the video recording format cannot be played back.
Depending on the recording status of a disc, the disc may not be played back at all or normally
(the picture or sound may be not be smooth, etc.).
*4: Scratched or stained discs may not be played back.
*5: Some discs cannot be played back because of incompatible recording conditions, characteristics of the
recorder or special properties of discs.
DVD-Video
*1,2,4
*1,3,4,5
* 1,3,4,5
* 4
* 4,5
or
DVD-R
DVD-RW
DVD+R
DVD+RW
Audio CD
CD-R
CD-RW
Digital video
(MPEG2)
-
- -
-
-
Digital audio
or
MP3
Digital audio
or
MP3
Region code Mark (logo)
Playable
discs
Recorded
signals
Disc size Disc types
12 cm
or
8cm
12 cm
or
8cm
12 cm
or
8cm
Example
Title 1 Title 2
Chapter 1 Chapter 2 Chapter 1 Chapter 2 Chapter 3 Chapter 4
Example
Group 1 Group 2
Track 1 Track 2 Track 5 Track 6 Track 3 Track 4
Example
Track 1 Track 2 Track 5 Track 6 Track 3 Track 4
About the Discs
Playable Discs
Unplayable Discs
¡ On the following discs, only the sound can be heard (picture cannot be viewed).
CDV
CD-G
¡ NEVER play back the following discs. Otherwise, malfunction may result!
DVD-RAM
CD-I
Photo CD
Video CD.
DVD with region codes other than 1 or ALL.
DTS-CD
DVD-ROM for personal compurters.
CD-ROM for personal computers.
SACD
¡ Any other discs without compatibility indications.
If channel 3 is already occupied for broadcasting,
1) Set your TV to channel 4.
2) Insert a pre-recorded tape into this unit.
3) Press the PLAY button once.
4) After a few seconds, press the PLAY button on the DVD/VCR for 3 seconds.
• The RF output channel will change to channel 4 from channel 3 and you will see a playback picture.
• When a picture does not appear on the TV screen, repeat step [4].
5) Press the STOP button to stop playback.
Hint Hint
• The RF output channel may
not change when you adjust
tracking during playback. In
this case, stop the playback,
and start the playback again.
After that, press the PLAY
button on the DVD/VCR for 3
seconds again.
RF Output Channel
Connections
Please refer to “Basic TV Connection” on cover page before you use this unit.
H9600UD(EN)v1.qx33 03.12.8 10:50 AM Page 5