Onkyo DV-SP502E - Manual (Page 19)

19
Connecting the DV-SP502/DV-SP502E—Continued
The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In
this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protection technol-
ogy. Do not connect this player to your TV via a VCR
using AV cables, as the picture from this player will
not appear properly on your TV. (This player may also
not be compatible with some combination TV/VCRs
for the same reason; refer to the manufacturer for more
information.)
1. Connect the VIDEO OUTPUT and AUDIO OUT-
PUT ANALOG L/R jacks to a set of A/V inputs
on your TV.
Use the supplied AV cable (RCA), connecting the
red and white plugs to the audio outputs and the yel-
low plug to the video output. Make sure you match
up the left and right audio outputs with their corre-
sponding inputs for correct stereo sound.
See the following page if you want to use a compo-
nent or S Video cable for the video connection.
If you need another pair of stereo outputs (and don’t
need to use the multichannel analog outputs), you
can use the FRONT/D.MIX 1 or 2 AUDIO OUTPUT
jacks (page 22).
2. Connect the supplied AC power cord to the AC
INLET, then plug into a power outlet.
Notes:
• Before unplugging the player from the power outlet,
make sure you first switch it into standby using either
the front panel STANDBY/ON button, or the remote
controller, and wait of the “GOOD BYE” message to
disappear from the player’s display.
• For the above reasons, do not plug this player into a
switched power supply found on some amplifiers and
AV receivers.
Basic Setup
AC INLET
REMOTE
CONTROL SUPER AUDIO CD & DVD AUDIO/
VIDEO PLAYER
MODEL NO. DV-SP 502
RATING:
AC 120V 60 Hz
11W
VIDEO
S VIDEO
R
L
SURR CENTER 1 2
FRONT/D. MIX
AUDIO OUTPUT
DIGITAL
SUB
WOOFER
OPTICAL
COAXIAL P B Y
P R
COMPONENT
VIDEO OUTPUT
L
R
ANALOG
INPUT
VIDEO IN
To power outlet
TV
AV cable
(Supplied)
Power cord
(Supplied)