Osburn Stoves by SB I HYBRID 35 - Manual (Page 19)

19
OPERATING THE STOVE USING A THERMOSTAT
A thermostat will help you maintain a constant house temperature
automatically. A millivolt or 24 Volt thermostat is required. A fixed wall
mount or remote model can be used.
THERMOSTAT INSTALLATION
•
Unplug the stove from the power outlet.
• Connect two thermostat wires to the terminal block located on the
lower right side of the back of the stove. To do so, loosen the two
screws and insert the wires in the terminals. Tighten the two screws.
(See Figure 41)
• If you are using a wireless wall thermostat or a hand held thermostatic
remote control, you can locate the receiver behind the stove’s back
panel, on the right side, just below the terminal block. Most receivers
are already equipped with quick-connect terminals. Simply unplug the
PC board wires connected to the back of the terminal block and
connect them directly with the receiver’s terminals. Location of the
thermostat is very important to obtain the best comfort and efficiency
from you HYBRID-35. The thermostat should be mounted 50 inch
from the floor on a wall located 15 to 20 feet from the stove. You
should avoid installing directly in front of the stove to avoid
cycling.(See Figure 42)
THERMOSTAT
WIRE TERMINAL
Figure 41
Thermostat terminal