Oregon WRB308 - Manual (Page 11)

EN
11
DATA TRANSMISSION
Data is sent from the sensor approx. every 60 seconds.
The reception icon shown in the Outdoor Temperature /
Humidity Area indicates the status.
ICON DESCRIPTION
Main unit is searching for sensors
Selected sensor has been found
Sensor 1 is sending data. (The
number shows which sensor is
selected)
--- shows in Temp / The selected sensor cannot be
Humidity Area found. Search for the sensor or
check batteries
SEARCH FOR SENSOR
To search for the temperature-humidity sensor,
simultaneously press and hold MEMORY and
CHANNEL on the weather station.
NOTE If the sensor is not found, check the batteries.
WEATHER STATION
This product tracks the time and date based on radio-
controlled signals from the RTGR328NA sensor or
manual settings that you enter.
ATOMIC CLOCK
The sensor automatically synchronizes the current time
and date on the clock when it is brought within range of
the WWVB-60 atomic clock signal generated from Fort
Collins, Colorado. For more information, please visit:
www.boulder.nist.gov/timefreq.stations/radioclocks.htm
The signals are collected by the remote sensor whenever
it is within 932 miles (1500 km) of a signal.
Initial reception takes 2-10 minutes, and is initiated when
you first set up the sensor, and whenever you press
RESET. If the RF signal is weak, it can take up to 24
hours to get a valid RF signal reception. Once complete,
the reception icon will stop blinking.
The icon shown in the Clock Area indicates 2
factors:
• Connection between the weather station and the
sensor that collects atomic clock signals ( )
• Atomic clock signal reception ( )
How these signals work together:
ICON MEANING
The unit has contact with the sensor
and has synchronized the time
The unit has contact with the sensor
but the time has not been
synchronized
WRB308 M_EN_V6.P65 2005.5.30, 9:49 11