Olympus DS-333 - Manual (Page 68)

68
When recording voices for use in voice
recognition, set up your DSS recorder
as follows to facilitate recognition.
• Set the microphone sensitivity to "DICT".
(
☞ P.19)
• Set the recording mode to "SP". (
☞ P.18)
• Set the Variable Control Voice Actuator
(VCVA) to "OFF". (
☞ P.16)
• Only record voices that have already been
registered in the voice recognition software
speak.
• Record in a relatively quiet environment.
• Have the person speaking within 5-10 cm
of the built-in microphone of the recorder
(5 to 10 cm).
• Speak continuously.
Voice files recorded under the following
conditions cannot be processed by
voice recognition because their
recognition rates may be very low.
• A conference or meeting where the voices
of many people have been recorded.
• Seminar or lecture in which ambient noise
tends to be recorded.
Notes on Recording For Voice Recognition
Using V
oice Recognition Software (optional)
Using Voice Recognition Software (optional)