Appendix d – setting up, Resiting the scancopier, Locking the scanning head – Oki S900 User Manual
Page 65: Resiting the scancopier locking the scanning head
APPENDIX D – SETTING UP > 65
APPENDIX D – SETTING UP
Although your Scancopier (and optional ADF) will have been fully
installed by an Installation Engineer, you may require to resite the
Scancopier or fit an ADF at a later date or change your user default
settings. In such events, you should read the relevant sections of the
following information.
RESITING THE SCANCOPIER
LOCKING THE SCANNING HEAD
1.
Turn the power off the Scancopier.
2.
If the scanning head is not located at its home position (1),
turn the Scancopier on to return the scanning head to position
(1).
3.
After the scanning head is returned to the home position, turn
the Scancopier off.
CAUTION!
Before moving the Scancopier you must remove the power from it, lock
the scanning head and disconnect any cables that may be attached to
it.
1