Printhead gap, Carbon forms, Extra-thick forms – Oki 391 User Manual
Page 55: Printhead gap setting, Multipart and printhead gap, Types, and printhead gap, Definition, Extra-thick continuous forms, Setting, Settings, and media types
|
User’s Guide: English
55
Printhead Gap
The printhead gap is the distance between the printhead and
the platen.
!
Make sure the printer is turned off before you open the
access cover.
To adjust the gap, open the access cover and move the blue
lever (1) to the recommended setting from the table.
32T-35.eps
Media
Setting
12-20 lb paper
1
20-24 lb bond paper
2
Labels
3 or 4
Envelopes
4 or 5
2-part form (with carbon)
1 or 2
3-part form (with carbon)
2 or 3
4-part form (with carbon)
3 or 4
5-part form (with carbon)
4 or 5
6-part form (with carbon)
5
!
For dedicated, bottom-feed printing of extra-thick
continuous forms (requires optional push and/or pull
tractor), the printhead gap range can be expanded to
take forms up to 0.031" (0.79 mm) thick. For more
information, refer to “Using Your Printer, Printhead
Gap, Expanded Printhead Gap.”
1