Oreck XL2205RH - Manual (Page 4)

2
4
Assembly
To Replace Paper
Filter Dust Bag
WARNING: Unplug cord from
electrical outlet before servicing.
With ON/OFF switch facing
the front of the unit, slide
upper handle section over
matching section of the
connector assembly. Insert
short screw into top hole and
long screw into bottom hole
then tighten firmly until handle
is no longer loose.
1
2
3
4
9
10
11
14
15
12
13
5
6
7
8
To assist you in identifying
components of your vacuum,
the parts have been numbered
as follows:
1 Handle tube, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener
10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
Before assembling appliance,
remove two screws from
connector assembly. Remove
cardboard insert by pulling
upward.
1
Attach cord to cord clip by
pressing cord above and below
clip ensuring the cord is fully
rested in clip.
3
BAG REMOVAL:
1. Unsnap bag door from base.
2. Gently pull bag from
cardboard collar upwards.
3. XL2605HH: Dust seal will
close automatically
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock
door.
2. Firmly push bag dock door
with both thumbs on
indication point until
it snaps.
PRESS
UNTIL SNAP
IS HEARD
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HAST A
ESCUCHAR UN
CHASQUIDO DE SUJECI УN