Oki Pos 441 - Manual (Page 23)

–  –
Caution Symbol
This symbol is placed near the print head to indicate that it may be hot. Never touch
the print head immediately after the printer has been used. Let the print head cool
for a few minutes before touching it.
This symbol is placed near the cutter (auto cutter or manual cutter tear bar).
Never touch the cutter blade, as you could injure your fingers.
This symbol label or stamp is placed near the screws securing the case, which should
not be opened by individuals other than service personnel.
Individuals, other than service personnel, should not remove these screws.
High voltage areas in the case can be dangerous.
WARNING
3 Shut down your equipment immediately if it produces smoke, a strange odor, or unu-
sual noise. Immediately unplug the equipment and contact your dealer for advice.
3 Never attempt to repair this product yourself. Improper repair work can be danger-
ous.
3 Never disassemble or modify this product. Tampering with this product may result in
injury, fire, or electric shock.
3 Do not touch the cutter blade.
- There is a cutter inside the paper outlet slot. Not only should you not put your hand
in the paper outlet slot while printing is in progress, never put your hand into the
outlet even when printing is not in progress.
- The printer cover can be opened when replacing the paper. However, since the cutter
blade is on the inside of the printer cover, be careful not to place your face or hands
too close to the cutter blade.
3 During and immediately after printing, the area around the print head is very hot. Do
not touch it, as you could be burned.
3 Since working on the cutter may be dangerous, be sure to turn off the printer first.