Using an oreck fresh air tab, Assembly – Oreck MICRO SWEEP 2005HH User Manual

Page 4

Advertising
background image

A

B

4

To Replace Filter

Dust Bag

BAG INSTALLATION:
1. Hook bottom of bag collar

opening under lip “B” of
connector assembly. Pull up
on bag collar and snap over
lip “A” of connector.

2. Press on edges of bag collar

to insure bag is completely
installed.

IMPORTANT: Check to
make sure bag collar is
behind lips “A” and “B”. If it
is not, dust will leak into
outer bag. When filter bag is
in place, close outer bag
with zipper fastener.

WARNING: Unplug cord from
electrical outlet before servicing.

Your ORECK XL vacuum
cleaner has a special
FRESH AIR tab pocket. This
pocket is located inside the
outer bag in the area
where the disposable
paper bag attaches to the
intake tube. Insert tablet in
pocket.

Using An Oreck

Fresh Air Tab

1

2

3

4

9

10

11

14

15

16

17

12

13

5

6

7

8

To assist you in assembling your
cleaner, the parts have been
numbered as follows:

1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter dust bag
6 Power cord
7 Retaining spring
8 Bag tension bar
9 Zip fastener

10 On/off switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector assembly
14 Fan housing
15 Cord assembly
16 Handle Brace
17 Cord Strain Relief

Assembly

®

With On/Off switch facing the

front of the unit, slide upper
handle section over matching
section of the connector assembly.
Place brace against handle and
connector assembly aligning
screw holes. Insert short screw into
top hole and long screw into
bottom hole then tighten firmly
until handle is no longer loose.

Before assembling appliance,
remove two screws from connector
assembly. Remove cardboard
insert by pulling upward.

1

2

Connector

Assembly

Connector

Assembly

Upper

Handle

Brace

3

Attach cord to cord clip by

pressing cord above and below
clip ensuring the cord is fully rested
in clip.

Advertising
This manual is related to the following products: