Oreck HEATWISE HW1000P - Manual (Page 12)

9
Problem Solution
The heater’s airflow has been
reduced
• Make sure the electrostatic filter is clean.
• Check front grill and look behind rear air intake
for any objects that could obstruct air-flow.
• If the heater’s airflow is still diminished or has
stopped, please contact Customer Service.
The heater stays ON after I
push the Power Button to turn
it off
• This is a normal function of the heater. DO
NOT unplug the heater until you no longer hear
the fan running. During this time, the heater is
cooling down.
The heater’s display is show-
ing a line of dots
• This is part of the heater’s normal operation.
After a period of inactivity, the heater will enter
into a “screen saver” mode to conserve opwer.
This will not affect the heater’s operation. When
any function key is pressed, the heater’s display
will reappear.
Heater thermostat tem-
perature does not match wall
thermostat temperature
• Contact Customer Service to obtain
programming instructions for matching your
Heatwise thermostat settings with your existing
wall thermostat.
The heater will not turn on. • Test the outlet to make sure there is power
available and then check the heater display for
the flashing Time Delay Light. Press the Power
Button to turn off the timer and resume normal
operation of the heater.
Until still does not operate
properly.
• Contact Oreck for service.
Trouble-
shooting
Service problems that appear to be major can often be solved
easily. You can be your own troubleshooter by reviewing this guide.
All other servicing should be done by an Oreck authorized
service center.