Optoma Home Theatre Projector - Manual (Page 48)

User Controls
46
Lamp
This function can adjust setup about lamp.
 Lamp Hours: Displays the cumulative lamp operating time.
 Lamp Reminding: Choose this function to show or to hide the
warning message when the changing lamp message is displayed.
The message will appear up 30 hours before suggested
replacement of lamp.
 Lamp Reset: Reset the lamp life hour after replacing the lamp.
Film Mode (48Hz)
 On: Enables Film Mode (48hz) function. Use this mode if the source
device is capable of outputting 24fps.
 Off: Disables Film Mode (48hz).
Auto Power Off (mins)
Sets the interval of power-off of the system, if there is no signal
input. (In minutes)
Anamorphic Lens
 None: No Anamorphic Lens in front of the HD81-LV.
 Fixed: You have a fi xed Anamorphic Lens in front of the
HD81-LV.
 Movable: You have a powered Anamorphic Lens that support
12V Trigger to control.
When Anamorphic Lens set as “Fixed” or “Movable”, the default
format will become “Auto235” that replace original format
“Native”. (See page 35)
Settings copy
This function allow user copy image setting that user adjust from
one to another.
Reset
Returns the settings for all menus to factory default values.
Group 1 Group 2 Group 3 Group 4 Group 5
From
I/O HDMI
1/2/3 HDMI
1/2/3 HD 1/
HD 2
(RCA) HD 3/
HD 4
(BNC) D-Sub HD 3/
HD 4
(BNC)
D-Sub S 1/
S 2/
S 3
Video 1/
Video 2/
Video 3
Timing
480i 480i 480i 480i NTSC NTSC
480p 480p 480p 480p PAL PAL
576i 576i 576i 576i
576p 576p 576p 576p
720p 720p 720p 720p
1080i/p 1080i 1080i 1080i
PC PC PC
(*) HD mean Component; PC signal only can copy to PC signal
 “Film Mode
(48Hz)” function is
only supported under
HDMI mode.