Omega Vehicle Security OME-PIO-D56 - Manual (Page 38)

3.3.6 Interrupt Polarity Control Register
(Read/Write): wBase+0x2A
Bit 7
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 0 0 0 INV3 INV2 INV1 INV0
Note. Refer to Sec. 3.1 for more information about wBase.
INV0=1Æ select the non-inverted signal from PC0
INV0=0Æ select the inverted signal from PC0
outportb(wBase+0x2a,0x0f); /* select the non-inverted input PC0/1/2/3 */
outportb(wBase+0x2a,0x00); /* select the inverted input of PC0/1/2/3 */
outportb(wBase+0x2a,0x0e); /* select the inverted input of PC0 */
/* select the non-inverted input PC1/2/3 */
outportb(wBase+0x2a,0x0c); /* select the inverted input of PC0/1 */
/* select the non-inverted input PC2/3 */
Refer to Sec. 2.4 for more information.
Refer to DEMO5.C for more information.
3.3.7 I/O Selection Control Register
(Write): wBase+0xcc
Bit 7
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 0 0 0 0 Port2 Port1 Port0
Note. Refer to Sec. 3.1 for more information about wBase.
Port? = 1Æ this port is used as a D/O port
Port? = 0Æ this port is used as a D/I port
outportb(wBase+0xcc,0x00); /* configure Port0/1/2 as D/I port */
outportb(wBase+0xcc,0x04); /* configure Port0/1 as D/I port */
/* configure Port2 as D/O port */
OME-PIO-D56/PIO-D24 User Manual (Ver.2.1, Oct/2003, PPH-005-21) ---- 36