Oricom BIG BUTTON PHONE TP58 - Manual (Page 4)

3
3 Installation
3.1 Check contents of pack
The following items are supplied in this pack:
one telephone base one telephone handset
one short telephone cable one curly cord
one long telephone cable one operating Manual
one warranty card
3.2 Connect the handset and line cord
Connect the telephone handset to the base unit. Plug one end
of the curly cord into the socket on the handset. Locate the
socket on the base of the phone and plug the other end of the
curly cord into this.
Plug one end of the telephone cable (long for desk installation)
into the wall socket. Plug the other end into the socket located
in the indentation on the base of the telephone. Then feed the
cable through the cable guide.
3.3 Wall mounting
Method A. Use two screws for fixing. At the desired location
drill two holes one above the other, 83mm apart, and leave the
screws protruding 5mm from the wall. Now place the telephone
base over the screws and gently push forwards and then
downwards.
Method B. If you wish to fit to an existing telephone wall plate
with modular connector. Plug the short telephone line cord
supplied into the base of the phone; plug the other end into the
telephone wall plate socket. Position the mounting holes on the
base of the phone over the two protruding screws on the wall
plate. Gently push the phone flush against the wall plate then
slide the phone downwards locking it into place.