Oreck XL2000HH - Manual (Page 5)

5
E N G L I S H
Disposable Paper Filter Dust Bags
Disposable paper filter dust bags play a very important role in
the efficiency of your ORECK vacuum cleaner. The purpose of
the paper bag is to trap dirt, but at the same time it must be
porous enough to allow air to pass through. If the paper bag
becomes clogged, no air can pass through the cleaner and
cleaning cannot take place, regardless of the cleaner’s power.
Increase the CLEANING POWER of your cleaner by changing
the bag often.
To keep your cleaner operating at maximum efficiency, change
the dust bag frequently. DO NOT FILL ABOVE THE LINE
INDICATED ON THE DUST BAG.
Be sure the disposable paper filter dust bag is installed properly.
All paper dust bags are not the same. Your ORECK disposable
dust bags have been designed to be used with the ORECK
cleaner and using bags other than genuine ORECK disposable
bags will affect the cleaning ability of your cleaner and could
cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective operation
of the cleaner. If the belt becomes stretched or cut, it will cause
the revolving brush to stop completely or slow down. See instruc-
tions in the manual for replacing belt.
An extra belt is stored in the base plate of your cleaner. When
buying replacement belts, use ONLY ORECK genuine belts. Belts
other than ORECK belts will not operate the revolving brush
correctly and may create undue stress which will cause damage
to the motor and brush bearings. Using belts other than ORECK
belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated and
seated. Further lubrication is not required.
General Cleaner Care
At least once a month, check for and remove excessive lint,
string or hair from revolving brush.
Wipe the outside of the cleaner with a damp cloth. Also clean
the connector deflector assembly area, base of cleaner and fan
housing area. If there is dust in the outer bag, vacuum it or
shake it out.
A little preventative maintenance will keep your cleaner looking
new and will ensure continued cleaning effectiveness.
CAUTION—Wood Floors, Soft (Vinyl, Asphalt Tile, etc.)
Floor Surfaces and Polished Floor Finishes
Use floor and floor finish manufacturer’s recommended methods of
cleaning. The metal strip on the base of the cleaner could be damaged
if used on concrete or abrasive surfaces, and, therefore, cause
damage to wood floors
, soft (vinyl, asphalt tile, etc.) floor surfaces
and polished floor finishes . The roller brush may also scuff very soft
finishes. Do not operate the unit while in the upright and locked
position. Do not let the unit run while in any one stationary position for
any period of time. Keep the unit moving while in operation.
Celoc® Hypo-Allergenic Filter System
The CELOC SMMS outer bag of your vacuum cleaner is high
filtration medical material designed to filter the smallest of dust
particles. It is important the inside of the outer bag be cleaned.
Vacuum the inside of the outer bag or hand wash, turned inside
out, with warm water, and air dry. For best results, the CELOC
SMMS outer bag should be replaced once a year.
The CELOC
layered disposable inner dust bag must be replaced once a month
even if it is not full. Change it more often if it is used in extremely
dirty areas. Increase the cleaning power of your vacuum by
changing the bag often.
T o R eplace F ilter
D ust B ag
BAG INSTALLATION :
1. Hook bottom of bag collar
opening under lip “B” of
connector assembly. Pull up
on bag collar and snap over
lip “A” of connector.
2. Press on edges of bag collar
to insure bag is completely
installed.
IMPORTANT: Check to
make sure bag collar is
behind lips “A” and “B”. If it
is not, dust will leak into
outer bag. When filter bag
is in place, close outer bag
with zipper fastener.
WARNING: Unplug cord from
electrical outlet before servicing.
A
B