Oreck DUTCHTECH DTX 1200A - Manual (Page 7)

7
O perating I nstructions
BARE FLOOR
CARPET
Upholstery tool, crevice tool
and dusting brush can be
found in storage
compartment.
The standard nozzle is
adjustable for use on
carpets (without brush) or
hard floors (with brush).
To adjust suction, use the
suction control on the
handle.
Small accessories can be
used with friction wand or
handle alone.
Note: Under proper
operating conditions a
green indicator light on the
power nozzle will illuminate.
If roller brush becomes
stalled, a red indicator light
will illuminate. Remove clog
or source of stall, and press
the red reset button on the
back of the power nozzle to
continue use.
E N G L I S H
Check bag frequently or
when bag full indicator has
been activated.
Note: If picking up fine
debris, change bag more
frequently.
Switch the unit off. Unplug
unit from wall outlet. Open
the cover by lifting the
latch in front of the intake.
Remove dust bag by
raising handle on bag
carrier and lifting carrier
out.
Remove the bag from
carrier by pulling the
cardboard tag. The
Saniseal
® dust seal will
close automatically.
Insert a new bag into
carrier by sliding
cardboard into slots on
carrier until bag is fully
inserted. Bend rear part of
dustbag downwards.
Replace the carrier into the
unit.
Close the cover by
pressing it down until it
latches. The cover cannot
be closed if a bag is not
present or inserted
properly.
BAG FULL
INDICATOR
R eplacing F ilter B ag
INDICATOR
LIGHTS
RESET BUTTON