Onkyo TX SR507 - Manual (Page 96)

96
Troubleshooting
—Continued
Can’t record
• On your recorder, make sure the correct input is
selected.
• To prevent signal loops and damage to the AV
receiver, input signals are not fed through to outputs
with the same name (e.g., TV/TAPE IN to TV/TAPE
OUT or VCR/DVR IN to VCR/DVR OUT).
• When the Pure Audio listening mode is selected,
video recording is not possible because no video
signals are output. Select another listening mode.
The sound changes when I connect my
headphones
• When a pair of headphones is connected, the listening
mode is set to Stereo, unless it’s already set to Stereo,
Mono, Direct, or Pure Audio, in which case it stays the
same. (Pure Audio listening mode is not available for
North American/Taiwan models.)
How do I change the language of a multiplex
source
• On the “Audio Adjust” menu, change the “Input
(Mux)” setting to “Main” or “Sub” (page 71).
The functions don’t work
• To use , you must make an connection and an
analog audio connection (RCA) between the
component and AV receiver, even if they are
connected digitally (page 35).
• While Zone 2 is selected, the functions don’t
work.
The AV receiver’s display doesn’t work
• The display is turned off when the Pure Audio
listening mode is selected. Select another listening
mode.
The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these
settings.
1. While holding down the input selector button for the
input source that you want to set, press the [SETUP]
button.
2. Use the Left and Right [ ]/[ ] buttons to change
the setting.
3. Press the [SETUP] button when you’ve finished.
• Video Attenuation
This setting can be made for the DVD/BD,
VCR/DVR, CBL/SAT, or AUX input.
If you have a games console connected to the
composite video input, and the picture isn’t very
clear, you can attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.
Recording
Others
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least 5 seconds, and then plug it back
in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
this unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.