Oricom Secure 300 - Manual (Page 16)

14 BASIC OPERATION
Note:
Low battery alert can be suppresed by pressing any
button.
Charging the Battery
Place the parent unit on its charger pod to charge the
battery. When charging, the red light on the charger will
light steadily. The Low Battery light will be turned off.
Note:
The Parent Unit must never be operated on the charger
pod without batteries.
The parent unit can be used on or off the charger pod.
When on charger pod, the batteries will be recharged at
the same time. However, the time it takes to charge the
batteries to full will be longer when the unit is charged and
used at the same time.
Rechargeable batteries in the Parent unit give up to 12
hours continuous usage. Please note however, that new
batteries do not reach full capacity until they have been in
normal use for several days.
Running rechargeable batteries right down at least once a
week will help them last as long as possible. The charge
capacity of rechargeable batteries will reduce with time as
they age, so reducing the performance time of the parent
unit. Eventually they will need to be replaced.
Restore to Default Setting
You can return the baby and parent units to factory default
settings. The Parent and Baby units are reset individually.
• Press [ ] key to switch the unit off.
• Press and hold [ ] key again to switch the unit on.
• While the unit is switching on, press and hold [ ]
key on the parent unit or the [ – ] key on the baby
unit until you hear a beep. The unit will restore all the
original factory settings.
Note:
If
[ ] or [ – ] is not pressed within 4 seconds, the unit
returns to standby mode.
You will need to restore factory default setting on the Baby
Unit or on the Parent Unit individually to restore both units
to original factory settings.