Sylvania SRC21134 - Manual (Page 17)

- 17 - EN
9I03
PLAYBACK
NORMAL PLAYBACK
Make sure ...
• TV/VCR power must be turned on.
1 Insert a prerecorded tape
If the erase-protection tab has been removed, the
TV/VCR will start playback automatically.
2
To begin playback
Press the PLAY button.
Note: If any menu is activated on
the screen, the PLAY button does
not function. Press the MENU but-
ton to clear the menu, then press the PLAY button.
If a tape is already in the TV/VCR with the power
off, do either of the following:
A) Press the PLAY button on the TV/VCR. Power
will automatically turn on and playback will start.
B) Press the POWER button on the remote control to
turn the TV/VCR on, then press the PLAY button
on the remote control and playback will start.
3
To stop playback
Press the STOP button when play-
back is completed.
INSERTING A CASSETTE
Insert the cassette in the direction as shown. Push in
gently, but continuously, on the center-back of the
cassette until it is drawn into the TV/VCR. The
TV/VCR will automatically turn on.
CORRECT
Window
WRONG
This TV/VCR will operate with any cassette that has the mark. For best results, we
recommend the use of high-quality tapes. Do not use poor quality or damaged tapes.
PLAY B
STOP
PRECAUTIONS
• Avoid moisture. Moisture condensation may occur
on the tape if it is moved from a cold place to a
warm place or visa versa. Before using a tape with
these conditions, to avoid damage of the tape and
your TV/VCR, wait until the tape has warmed to
room temperature and the moisture has evaporated.
• Avoid extreme heat, high humidity and magnetic
fields.
• Do not tamper with the cassette mechanism.
• Do not touch the tape with your fingers.
FM MODE (SRC21134 only)
This function enables you to receive FM radio broad-
casting.
1 Set the FM mode
Press the TV/FM button on the
remote control. The radio frequency
appears on the TV screen.
2 Select the radio frequency you want to receive
Press the CHANNEL K or L button until your
desired radio frequency appears.
FM 88.0 MHz
NOTES:
•
FM mode is not available for model SRC21194.
• The radio frequency indication repeats to appear
and disappear.
• You can not record the FM radio wave broadcast-
ing.
• If you receive a weak radio signal, you may change
the FM Antenna mode to INT(internal) or
EXT(external) by following the step below.
1)Press the MENU button. Press the PLAY/K or
STOP/L button to point to “CHANNEL SET UP”.
Then, press the F.FWD/B button.
2)Press the PLAY/K or STOP/L button to point to
“FM ANTENNA”. Select [INT] or [EXT] using
the F.FWD/B or REW/s button.
T5215 _VA 01.2.21 7:13 PM Page 17